Air Techniques A/T 2000XR Dental Film Processor

Air Techniques A/T 2000XR Dental Film Processor - Distributed by Henry Schein
Air Techniques A/T 2000XR Dental Film Processor - Distributed by Henry Schein
Air Techniques A/T 2000XR Dental Film Processor - Distributed by Henry Schein
Air Techniques A/T 2000XR Dental Film Processor - Distributed by Henry Schein

Schedule a Demo

Request a Quote

A/T 2000XR X-Ray Film Processor

This equipment is warranted to be free from defects in material and workmanship for a period of 12 months from the date of installation by authorized Air Techniques' dealer service personnel.

Financing Opportunities

  • Finance Calculator

    Click to Request Product Financing Options

12 Month Warranty.

Panoramic Daylight Loader : PN 45110

Panoramic Flat Bottom Daylight Loader: PN 45115

  • Automatic chemistry replenishment and temperature maintenance.
  • A microcomputer automatically signals the internal replenishment pumps to meter the proper amount of developer and fixer to maintain chemistry strength. This ensures optimum chemistry strength and is more economical because excess chemistry is not used.
  • Stand-by mode for energy conservation. After films exit the processor, the A/T 2000 XR will automatically return to stand-by mode. Electricity use, water consumption and system wear are reduced.
  • Daylight Loader available. The optional Panoramic Daylight Loader and a Quick Loader Covered Feed Chute eliminate the need for a dark room.
Part Number 45000
Process Time Archival, 5 1/2 minutes. "Quick-look" Endo periapical films, 2 1/2minutes
Chemistry Replenishment At initial Power On, 4 1/4oz. in 90 seconds. Every 12 3/4" linear film, 1 2/3 oz. in 35 seconds
Electrical 115V, 60Hz, 8A. Use 3 prong grounded outlet. Dedicated 15 amp line recommended
Water Flow 1/2 gallon/minute when processing film. Do not use water softeners
Water Pressure 80 psi max. / 30 psi min. Manual shut-off required near processor
Water Connection 1/2" female NP and 3/4" male garden hose adapters provided. A 6' long water supply hose is provided to connect to the rear of the processor
Water Backflow Prevention Vacuum breaker not required. Processor has a 1" air gap between water supply inlet and top of highest water level in processor
Water Temperature Mixing valve not required if water temperature is between 55 degree F (13 degrees C) to 80 degrees F (27 degrees C)
Drain Use 1 1/2" diameter vertical PVC standpipe, open at top, connected to 1 1/2" PVC trap. Top of standpipe must be 6" below bottom of counter top. DO NOT DRAIN INTO COPPER OR BRASS. Ventilation: Room air must not exceed 80 degrees F (27 degrees C) during processing. Processing generates heat. Adequate ventilation of 10 air changes per hour is necessary to maintain darkroom temperature
Dimensions (HxWxD) 18"x15"x25" with leveling base. With Daylight loader, 18"x16.25"x39"; Daylight Loader extends additional 10.25" below counter top
Weight 90lbs with water and chemistry, 75lbs empty